Skip to content
Packing Rooms and Wash Bays

Urethane Cement for Aromas Packing Rooms and Wash Bays

A canner at a rolling boil all afternoon, a packing room hosed out after every pick, a wash bay where the pressure washer runs hot: those are the floors urethane cement was made for. Johnny Mendoza trowels it thick and carries it up the walls in a cove. He checks the slab for moisture first, because hillside pads around Aromas can stay damp well after the rains.

JP Resin Certified · Don Resin Certified · Hollister Based, Working the Aromas Hills

Highway 129 winds through Aromas near Highway 101, and Johnny comes over from Hollister.

Canning season is a thermal shock test

Boiling water is hard on a floor, and the problem is the swing more than the heat. A pot of jars comes off the stove, a splash hits a cool slab, and the surface expands fast while the floor under it stays put. A thin epoxy rides that stress for a while, then cracks or lifts at the edges. Do it every weekend from summer into fall and the failure comes sooner.

Urethane cement handles that swing because it behaves much more like the slab it sits on. It goes down in a thick troweled or slurry layer, around a quarter inch give or take, so a dropped canner or a full produce bin does not dent it. It also stands up to the acids in tomato juice, vinegar brine and fruit, which etch weaker finishes.

Every jar of jam that boils over is a small heat test for the floor.

The same goes for the other wet rooms on a small farm. A packing room where crates get rinsed and a shop wash bay full of grit and degreaser both get hosed down on purpose, and both punish seams. A floor with no joints and a cove at the wall leaves the water nowhere to sneak under.

Do not expect a showpiece. The finish is matte or lightly textured in a short list of earthy colors, and it looks like the working floor it is.

Workrooms Wet on purpose

The rooms a hose lives in

Each one gets washed down on a schedule, and each needs its own detail at the wall and the drain.

Farm packing room

Produce comes in dirty, crates get rinsed and the floor stays wet through every pick. A slurry finish with light texture keeps boots and pallet jack wheels steady, and the cove keeps rinse water off the base of the walls where rot and mold start.

Ranch shop wash bay

Mud off the trucks, hot water from the pressure washer and degreaser by the gallon. Urethane cement takes the heat and the chemicals, and a broadcast texture gives grip on a floor that is wet more often than dry. Slope to the drain gets checked first.

Canning and gathering kitchen

Some ranch houses keep a second kitchen for putting up the harvest and feeding a crowd for a holiday or a family party. Boiling water, sugar and vinegar land on it, then a mop every night. Coved bases make the corners easy, and the floor goes back into use quickly.

Small processing room

A room where honey gets extracted or meat gets cut and wrapped gets scrubbed with sanitizer every single day. Urethane cement holds up to that routine and leaves no seams to trap residue. Johnny matches the topcoat to the sanitizer on your shelf, so bring the label.

Hillside pads and seasonal ground water

Around Aromas, a lot of buildings sit on pads cut into a hillside. Water from the slope above runs toward them every rainy season, and the ground under the slab can stay wet for months after the last storm. Older shops and barns were often poured right on that soil with no vapor barrier, so moisture keeps moving up through the slab long after the surface looks dry.

Moisture rising through a slab is the usual reason an epoxy floor blisters and peels. Urethane cement puts up with a good deal more of it, which is a big part of why it suits a hillside workroom. That tolerance has limits, so Johnny reads the slab first with probes set into it. If the numbers come back high, the plan picks up a moisture primer, and you see that line before work starts.

Grading matters too. A slab with water sheeting against its uphill wall every winter needs that water pointed somewhere else before it finds its way under the wall and onto the new floor. Johnny looks at the outside of the building on the walk, where the downspouts go and which way the ground falls, and tells you if a drainage fix belongs ahead of the floor.

Read the slope outside before you choose the floor inside.

Drains, slopes and the doorway to the yard

Inside, water has to know where to go. Johnny checks the fall toward each floor drain before anything is mixed, and the coating gets feathered down into the drain body and sealed at the rim so no lip catches dirty water. In a packing room with no drain at all, he talks through squeegeeing to a door or a trench, and where that water ends up outside.

The door to the yard is the other weak point. Mud and oak leaves come in on every boot and tire, and the threshold takes the worst of it. The floor gets a firm edge there, a little more texture in the first stretch inside, and a termination built to take a loaded cart bumping over it. Any old fuel stains near that door get pulled out before priming.

Return to service is quick compared with most floors, though cure time depends on the system and how warm the room is. For a home kitchen, plan the work before canning season rather than in the middle of it. Johnny works out of Hollister, a neighbor to Aromas, so the site assessment fits around your week. The full rundown on the material is on our urethane cement page.

What Aromas growers and home cooks ask

Can it handle a pressure canner and a water bath running all afternoon?

Yes. Splashes of boiling water and steam are exactly the kind of heat swing urethane cement is built for. The bigger risk in a canning kitchen is sugar and vinegar sitting in corners, so the coved base matters as much as the heat rating. Wipe syrup spills the same day and the floor stays easy to clean.

Our packing room has no floor drain. Can it still get urethane cement?

It can. The floor goes down to follow the slab you have, so Johnny checks which way it already falls and plans the cleanup around that, usually squeegeeing toward the door. If you have wanted a drain for years, the time to add one is before the floor, and a plumber handles that part.

Will tomato juice or pickling brine mark the floor?

Urethane cement holds up well to food acids, which is why it shows up in commercial kitchens and processing rooms. A puddle of brine left for days can still dull the surface a little, the same as any floor. Rinse acidic spills at the end of the day and the finish keeps its look.

Our shop was built on a hillside cut. Will ground moisture be a problem?

It might be. Moisture coming up through the slab is something Johnny measures with probes, and urethane cement copes with more of it than epoxy. Water running against the uphill wall is a separate problem, and fixing that outside, with grading or a drain, often matters more than anything done to the floor.

Can the wash bay take a hot water pressure washer and truck degreaser?

Yes, as long as the topcoat is matched to the degreaser. Hot water is no problem for urethane cement. Strong degreasers vary a lot, so Johnny asks for the product name and picks the system to suit it. A broadcast texture keeps your footing on a floor that is wet most of the time.

Does it need a fresh coat every year like a garage floor?

In most rooms, no. Urethane cement is thick and wears slowly, and there is no yearly recoat to plan around. Where carts turn or a door sees heavy traffic, a worn lane can be cleaned up and topcoated later without redoing the room. Johnny points out those spots when the floor goes in.

Tell Johnny what gets washed in there

Send a rough size for each wet room, what you clean with and how hot the water runs. A photo of the drain and the doorway helps. Johnny comes over from Hollister, probes the slab, walks the outside of the building and writes up a price with the prep broken out on its own line.

Working floors sit beside the showpieces in our gallery. Have photos of the room? Send them through the contact page.